Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS & ACCESSORIES
A
Cook & Crisp tray
5.7L Removable Cooking Pot
B
Lid Handle
C
Cooker Lid
D
Heating Element
E
F
Control Panel
G
Cooker Base
Smart Switch
H
Air Outlet Vent
I
J
Condensation Collector
BEFORE FIRST USE
1 Remove and discard any
packaging material and tape
from the unit. Some stickers are
to be permanently kept on the
unit, ONLY remove stickers with
'peel here'.
2 Pay particular attention to
operational instructions,
warnings and important
safeguards to avoid any injury or
property damage.
3 Wash the removable pot, Cook
& Crisp tray and condensation
collector in warm, soapy water,
then rinse and dry thoroughly.
To order additional or replacement parts and accessories, visit ninjakitchen.eu.
38
ninjakitchen.eu
A
B
D
C
E
F
G
H
I
J
ACCESSORY ASSEMBLY & SMART SWITCH
ACCESSORY ASSEMBLY INSTRUCTIONS
COOK & CRISP TRAY
Top Position
Bottom Position
Use top position
Use bottom
for proteins and
position for
vegetables when
traditional steam
following recipe
and air frying
instructions for
capabilities.
Speedi Meals or
Be sure to
when using Grill.
reference charts
and recipes
for crisper
tray position
recommendations.
To set up the Cook & Crisp Tray in the top
position, first rotate the tray's legs outward,
so that they extend past the four corners of
the tray. The legs should sit on the ledges at
the base of each groove, allowing the tray to
remain elevated in the pot.
NOTE: Before placing the Cook & Crisp
Tray in the top position, make sure to add
any ingredients needed at the bottom of
the pot.
NOTE: Recipes using the Speedi Meals
function require that the Cook & Crisp
Tray be set up in the top position.
To set up the Cook & Crisp Tray in the
bottom position, rotate the tray's legs inward
so that they are turned against the underside
of the tray. This will allow the Cook & Crisp
Tray to rest at the bottom of the pot.
USING THE SMART SWITCH
The SmartSwitch allows you to change
between the two cook modes, which are
labelled on the switch for your reference:
•Rapid Cooker
•Air Fry/Cooker
The SmartSwitch's position will determine
which cooking functions are available for
selection.
HOW TO OPEN & CLOSE THE LID
To open or close the lid at any time, use the
handle that is located front centre of the unit,
just above the control panel.
You can open and close the lid when the
SmartSwitch is in either the RAPID COOKER
or AIR FRY/COOKER position.
REMOVING & INSTALLING THE
CONDENSATION COLLECTOR
To install the condensation collector, slide it
into the slot on the cooker base. Slide it out
to remove it for hand-washing after each use.
NOTE: Make sure to empty out excess
water collected in the condensation
collector after cooking.
ninjakitchen.eu
39
Publicidad
