GYS ARCPULL 200 Manual De Instrucciones página 27

Operating manual
location, which is the case, for example, the hull of a ship or steel frameworks of buildings, an earthed connection can in some cases,
and not systematically, reduce emissions. Care should be taken to avoid the earthing of parts which could increase the risk of injury
to users or damage to other electrical equipment. If necessary, the connection of the workpiece to earth should be made directly,
but in some countries; rules may not allow such a direct connection, he connection should be made with a suitable capacitor chosen
according to national regulations�
f. Protection and shielding: The selective protection and encasing of other cables and equipment in the surrounding area may limit
interference problems. The safeguarding of the entire welding area may be considered for special applications.
THE TRANSPORTING AND MOVING OF THE MACHINE'S POWER SOURCE
The machine is equipped with a handle to easy transportation. Be careful not to underestimate its weight. The
handle cannot be used to hang or attach the machine on something else�
Do not use the cables or gun to move the welding power source. It should be moved in an upright position.
Do not carry or transport the power source overhead of people or objects.
Never lift the machine while there is a gas cylinder on the support shelf. Their transportation requirements are
different.
SETTING UP THE EQUIPMENT
• Place the welding power source on a floor with a maximum inclination of 10°.
• The welding power source should be protected from heavy rain and not exposed to direct sunlight.
• The equipment has an IP33 protection rating, meaning:
- its dangerous parts are protected from being entered by objects greater than 2.5 mm and,
- it is protected against rain falling up to 60° from vertical.
• Power cables, extension cables and welding cables should be fully unwound to avoid overheating.
The manufacturer assumes no responsibility for damage to persons or objects caused by improper and dangerous
use of this equipment.
MAINTENANCE/ADVICE
• Maintenance should only be carried out by a qualified person. Annual maintenance is recommended.
• Switch off the power supply by pulling out the plug, and wait two minutes before working on the equipment. Inside, the
voltages and currents are high and dangerous�
• Regularly check the condition of the power cable. If the power cable is damaged, it must be replaced by the manufacturer,
its customer service department, or a similarly qualified person, to avoid any danger.
1. DESCRIPTION OF THE PRODUCT
.
The GYSPOT ARCPULL 200 is a single-phase inverter arc-welding machine that can be used to weld inserts (pull rings studs, insu-
lation pins) on aluminium or steel based materials. It has a Synergic operating mode, and a Manual operating mode.
Fig 1: External view of the power source
1
2
5
6
1 Keypad
2 ON/OFF switch
3 Positive texas socket for gun beam
4 Negative texas socket for gun beam
5 Connector for gun beam control plug
6 Gas outlet for gun beam
7 Gas inlet to be connected to the cylinder
8 Protective cap for USB update port
Translation of the original
instructions
8
3
4
ARCPULL 200
10
7
27