Dremel 6300 Instrucciones De Funcionamiento Y Seguridad página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DM 2610958399 07-08.qxp
SLIDE "ON/OFF" SWITCH
The tool is switched "ON" by the slide switch
located on the topside of the motor housing.
TO TURN THE TOOL "ON", slide the switch
button forward.
TO TURN THE TOOL "OFF", slide the switch
button backward.
ELECTRONIC FEEDBACK
Your tool is equipped with an internal
electronic feedback system that provides a
"soft start", which will reduce the stresses that
occur from a high torque start. The system
also helps to keep the preselected speed
virtually constant between no-load and load
conditions.
VARIABLE SPEED CONTROL DIAL
This tool is equipped with a variable speed
control dial (Fig. 6). The speed may be
controlled during operation by presetting the
dial in any one of ten positions.
OPERATING SPEEDS
The Dremel Multi-Max consists of an AC
universal motor and oscillating mechanism to
perform applications such as cutting, grout
removal, scraping, sanding and more.
8/6/08
2:15 PM
Page 9
The Dremel Multi-Max has a high oscillating
motion of 10,000 - 21,000 opms. The high
speed motion allows the Dremel Multi-Max to
achieve with excellent results. The oscillating
motion allows the dust to fall to the surface
rather than slinging particles into the air.
To achieve the best results when working
with different materials, set the variable
speed control to suit the job (See Speed
Chart on Page 10 for guidance) . To select
the right speed for the accessory in use,
practice with scrap material first.
NOTE: Speed is affected by voltages
changes. A reduced incoming voltage will
slow the OPM of the tool, especially at the
lowest setting. If your tool appears to be
running slowly, increase the speed setting
accordingly. The tool may not start at the
lowest switch setting in areas where outlet
voltage is less than 120 volts. Simply move
the speed setting to a higher position to
begin operation.
FIG. 6
The variable speed control settings are
marked on the speed control dial. The
settings for approximate OPM's are:
VARIABLE SPEED
CONTROL DIAL
You can refer to the charts on next page to
determine the proper speed, based on the
material and accessory being used. These
charts enable you to select both the correct
accessory and the optimum speed at a glance.
-9-
Switch Setting
2
4
6
8
10
Speed Range
/min (OPM)
10,000-11,000
11,000-13,000
13,000-16,000
16,000-19,000
19,000-21,000

Publicidad

Tabla de contenido
loading

Tabla de contenido