JFA Electronicos X-LINE Manual De Instrucciones página 10

X-LINE SOURCES AND CHARGERS - INSTRUCTION MANUAL
CCA METER FUNCTION (Cold Start Current Meter)
To perform CCA measurement, simultaneously press the SELECTOR READING and
SELECTOR MODE keys.
When the CCA METER function is activated, the STORM Source disconnects from the AC
power grid, disconnects the fan, and starts the battery test. When the display displays the CCA-
BATXXX information, press the BATTERY SELECTOR switch to select the battery capacity to be
tested. During this process, the display displays the word CCA flashing. After 10 seconds, the display
displays the CCAXXX information, which can range between 20A and 999A, with the CCA value
obtained in the reading and RiXXXX (internal battery resistance) in mΩ the percentage of battery
charge is displayed in comparison to a new battery (selected at the beginning of the test).
This function can be used to test a battery bank that is within the maximum source
specifications (for parallel connection, add CCA of each battery) however, it is more indicated that
the test is done on individual batteries.
For proper operation, use 50mm2 x 30cm cables for 200A and 150A sources; 35mm2 x
30cm for 120A sources; and 16mm2 x 30cm for 70A, 60A and 40A sources; and make sure that the
supply terminals are correct ly so in the terminals to the battery terminals.
BATTERY CHECK-UP FUNCTION (Cumulative Charge Meter)
To perform a BATTERY CHECK-UP, proceed:
The battery must be discharged to approximately 11V voltage.
Turn on the source, press the key SELECTOR READING until the mode BATTERY CHECK-UP
is active (VOLTAGE and CURRENT LEDS ON). To reset the counter, hold down the key SELECTOR
READING by 5 Seconds.
CONTROL PANEL
PAINEL DE CONTROLE
PAINEL DE CONTROLE
BATTERY CHECK-UP
CHECK-UP DA BATERIA
CHECK-UP DA BATERIA
VOLTAGE AMPERAGE
TENSÃO CORRENTE
TENSÃO CORRENTE
READING SELETOR
SELETOR
1
LEITURA
SELECTOR LEITURA
MEDIDOR
MEDIDOR
CCA - Ri m
CCA - Ri m CCA - Ri m
METER
1
SELETOR SELETOR
MODE
MODO
MODO
SELECTOR
SELETOR SELETOR
SELECTOR
CARGA CARGA AUTO AUTO TENSÃO TENSÃO BATERIA BATERIA TENSÃO TENSÃO
SLOW AUTO OUTPUT BATTERY VOLTAGE
LENTA LENTA SCI SCI
SAÍDA SAÍDA
CHARGE ICS VOLTAGE s u p e r - x
CONTROL PANEL
BATTERY CHECK-UP
VOLTAGE AMPERAGE
READING
SELECTOR
1
CCA - Ri m
METER
MODE
SELECTOR
SELECTOR
SLOW AUTO OUTPUT BATTERY VOLTAGE
s u p e r - x
CHARGE ICS VOLTAGE
SLOW CHARGE
CARGA LENTA
PHASES
CARGA LENTA
1. ELEVAÇÃO
1. ELEVAÇÃO 1.ELEVATION
2. ABSORÇÃO 2. ABSORÇÃO
2.ABSORPTION
3. EQUALIZAÇÃO
3. EQUALIZAÇÃO
3.EQUALIZATION
BATERIA BATERIA
CHARGED
CARREGADA CARREGADA
BATTERY
SLOW CHARGE
PHASES
1.ELEVATION
2.ABSORPTION
3.EQUALIZATION
CHARGED
BATTERY
8