JFA Electronicos X-LINE Manual De Instrucciones página 7

X-LINE SOURCES AND CHARGERS - INSTRUCTION MANUAL
Each Source 40A, 60A, 70A, 120A, 150A and 200A can power about 2,000, 3,000, 3,500,
6,000, 7,500 and 10,000 Wrms of sound playing respectively, provided that a parallel battery is
used to supply the peak consumption.
When connecting to the batteries, observe the correct polarity of the connection and use
the appropriate cable gauge, according to the MINIMUM GAUGE table OF THE CABLES FOR
CONNECTION (see page 11). In battery-powered systems, the source should always be connected to
the battery and the battery to the amplificators (the connection point should always be made in the
battery post).
You can use as many Fonts (40A, 60A, 70A, 120A, 150A and 200A) that are required to
power the sound, with reference that each one keeps about 2,000, 3,000, 3,500, 6,000, 7,500 and
10,000 Wrms of sound playing respectively.
Another important point to note is that, operating in parallel, the sources must be in the
same OPERATING MODE, example:
AUTO SCI MODE: All sources must be in SCI.
OUTPUT VOLTAGE MODE: All sources must have the same output voltage.
SLOW LOAD MODE: Only one source must be on, the others o .
SERIAL CONNECTION - HIGH VOLTAGE
+
-
12V
12V
12V
Amplifier
12V
PARALLEL CONNECTION
12V
+
-
12V
12V
5