Mettler Toledo SevenGo Duo pro SG78 Instrucciones De Manejo página 16

4 Press
5 Press MODE/EXIT to return to the measurement screen.
4.6 Navigating within a menu
This example is based on the Setup menu, but the procedure applies to the other menus as well.
Press Menu.
The Setup menu appears and Sample ID is highlighted.
Press
Press Select to move deeper in the menu for the chosen operation.
Continue navigating with
Press MODE/EXIT to go back to the previous menu.
— or —
Press READ to return to the measurement screen directly.
4.7 Using the alphanumeric keypad
4.7.1 Alphanumeric input
The meter has a screen keypad for entering IDs, SNs and PINs. Both numbers and letters are allowed for these
entries.
Note
When entering a PIN, each character entered will be displayed as ( * ).
1 Press
downwards.
2 Press READ to confirm the entry.
The line where the position of alphanumeric character is being entered blinks.
3 To end and confirm entry, use softkeys to highlight screen key OK, and press READ to save the ID.
— or —
4 To delete information, use softkeys to highlight
character.
— or —
5 Press MODE/EXIT to return to the upper level of the menu.
The entries are rejected.
4.7.2 Entering IDs/PIN
The three softkeys and READ key are used for navigating on the keypad and entering the ID/PIN.
Example: WATER
1 If A is highlighted, press
V is highlighted.
12 Operating the pH/ORP/Ion/Conductivity meter SG78​ ​
to highlight the Cond. tab.
as often as needed to navigate to a menu item.
, or Select until the final destination is reached within the menu.
to move left to highlight number or letter, use
three times.
to move right, and
and press READ to delete the previously entered
to move
SevenGo Duo pro™