JULIUS MAYER Baureihe JM35 Manual De Instrucciones página 23

Mounting the engine mounts
You can choose - depending on the motor type and mounting situation - between diffe-
rent motor bearings. Either you decide to mount the standard star or flat bearing
which the square spigot on the motor head is inserted and secured with a split pin, or you
2
use the click bearing
and allows you to „click" the motor head into the bearing - without additional securing
with a split pin.
Mounting the click bearing (JM35 motors)
1. Using a Phillips screwdriver, remove the two screws on the motor head, remove the
bearing plate and pull the square peg out of the motor head
2. Attach the metal motor head plate of the click bearing to the motor head using the
supplied screws 4
ATTENTION!
Never use screws other than those included in the scope of delivery!
3. Mount the click bearing (plastic) on the side wall of your roller shutter box
Make sure that the bearing is mounted "centered".
In the case of stem elements, you can leave the round pin in the side panel, as it fits
exactly into the central recess of the click bearing as well as into the now accessible
opening in the motor head.
4. Now you can click the motor head plate into the bearing
Make sure that the lateral hooks of the click bearing engage on the motor head plate.
, which is included in the scope of delivery for the 35 mm motors
.
1
, into
3
.
5
.
6
.
ASSEMBLY
1
2
3
4
5
6
23