Samsung VR30T85 Serie Manual De Instrucciones página 41

Symptom
The Jet Bot suddenly cleans
diagonally.
Jet Bot does not clean some
places.
The Jet Bot cannot find a room.
The map which the Jet Bot has
created is different from the
saved map and the map is also
drawn askew.
Empty Dust function does not
work.
• Check if the Clean Station is installed along the grain of
wooden floors or tiles.
• The Jet Bot may clean in a diagonal direction if it is
moving to another area using the shortest route. It
may also move at a diagonal if it did not make contact
with an obstacle at a right angle, if it was charged in
a skewed direction at the Clean Station, or If the floor
material is wooden or tile.
• Check whether the Clean Station is installed in a narrow
passage or near a room door and move it to another
place.
– If the Clean Station is installed in a narrow passage
or near a room door, the Jet Bot cannot pass through
the passage or the door.
• Check whether the places the Jet Bot does not clean are
set as No-go Zones.
• If the Jet Bot does not start cleaning from the Clean
Station, or if the Clean Station is reinstalled to a new
position of 45 degree or 1 m or more from the previous
installed place, the Jet Bot cleans all areas, which is not
based on the created map.
– Start cleaning from the Clean Station.
– When the Jet Bot creates a map and the Jet Bot
starts cleaning, make sure the Jet Bot starts
operating parallel to the wall.
– Remove obstacles within 0.5 m of the left and right
side and 1 m of the front side of the Clean Station.
• If the battery is too low, the Empty Dust function does
not work. Charge the Jet Bot sufficiently, and run the
function again.
• Check whether the Clean Station's cover is open or the
Dust Bag is full.
• Check the time to empty Dustbin at the SmartThings
App. If it is set as "When the robot vacuum's dustbin is
full", the Empty Dust function does not work until the
Dustbin is full.
• If the Empty Dust function does not work properly,
press the [ ] button on the body of the Jet Bot while
it is charging, you can empty the Dustbin of the Jet
Bot manually. If you press the [
emptying, the dust emptying stops.
Checklist
] button during dust
English 41