Powersmart DB5021LED Manual De Instrucciones página 12

TROUBLESHOOTING
Problem Possible Causes
WARNING - Before attempting to make any inspections, repairs or adjustments, stop the snow thrower, wait for
all moving parts to stop moving and carefully disconnect the AC extension cord from the power source.
No power from AC
power source
Extension cord not
No start
connected
condition,
Extension cord faulty
won't not
Improper starting
turn on
procedure
Auger damaged or
blocked
Faulty switch, wiring or
motor
Auger damaged or
Turns on,
blocked
but won't
Chute blocked or
blow snow
damaged
Drive belt damaged
or loose
Extension cord faulty
Turns on, Improper extension
but won't cord
run at full
speed
Auger damaged or
blocked
Drive belt damaged or
loose
Faulty wiring or motor
CARE AND MAINTENANCE
WARNING
Make sure to turn off the switch and disconnect the extension cord before performing any maintenance task on
your snow thrower.
 Run the snow thrower for a few minutes to melt away any snow on the snow thrower. Turn the snow
thrower's power off.
 Disconnect the extension cord from the snow thrower.
 Examine the extension cord thoroughly for signs of wear or damage. Replace it if it is worn or damaged.
 Examine the snow thrower thoroughly for worn, loose bolts or damaged parts. For repairing or replacing
parts, contact customer service.
 Store the extension cord with the snow thrower.
 Store the unit in a locked and dry or high and dry place to prevent unauthorized use/damage and keep out
of the reach of children. Store the instruction manual along with unit for future use.
Remedy
Connect to known good AC power source
Securely connect extension cord at power source and
snow thrower
Connect a known good extension cord
Review "Powering ON and OFF" procedure in this
manual
Check auger for damage, blockage or frozen
condition, repair as required
Call customer service or contact service center
Check auger for damage, blockage or frozen
condition, repair as required
Check chute for damage or blockage, repair as
required
Check drive belt condition, repair as required (drive
belt is located on left side behind cover)
Connect a known good extension cord
Check extension cord length and gauge for use in proper
application, Review "Extension Cord Chart" in this manual
Check auger for damage, blockage or frozen
condition, repair as required
Check drive belt condition, repair as required (drive
belt is located on left side behind cover)
Call customer service or contact service center
12