Publicidad
Idiomas disponibles
Idiomas disponibles
3. To start, while holding the switch button in, pull the handlebar toward you until it
touches the handle. The switch button must be pressed in and held before pulling the
handle. Once the snow thrower starts, release the switch button.
4. To stop, release switch button.
USING LIGHT
1. Press button 1 to control the light. Press 1 time for high light, 2 times for low light,
and 3 times for flash. Press 4 times to turn off the light.
2. 2 is the charging port, The light switch displays red when charging and green
when fully charged.
MOVING THE MACHINE AND PLOWING THE SNOW
WARNING
Foreign objects, such as rocks, broken glass, nails, wire, or string, can be picked up and thrown by the snow
thrower, causing serious personal injury.
Remove all foreign objects from the area to be plowed before operating the snow thrower.
Keep the area of operation free of foreign objects that can be become thrown by the rotor blades.
Perform a thorough inspection of the area since some objects may be hidden from view by surrounding
snow, If the snow thrower hits an obstruction or picks up a foreign object during use, stop the snow
thrower, disconnect the extension cord, remove the obstruction, and inspect the unit for damage.
Repair or replace any damaged parts before restarting and operating the unit.
Keep children, pets, and bystanders away from the area of operation. Be aware that the normal noise of the
machine when turned on may make it difficult for you to hear approaching people.
When moving the snow thrower, use the wheels on the sides as the pivot point. Slightly tilt the snow
thrower on this pivot point to move it forward or backward.
Start your clearing path near the electrical outlet and work outward, throwing snow in a back and forth
motion, To clear in the opposite direction, stop over the cord and pivot the snow thrower on its wheels.
Make sure to overlap clearing paths.
Note wind direction. If possible, move in the same direction as the wind so that the snow is not thrown
against the wind (and thus back into your face and back onto the patch).
While moving the snow thrower, do not drag the power cable violently or roughly. The snow thrower
should move within the range that the cable can reach.
Do not push the snow thrower with excessive force. You should push machine gently and evenly in
accordance with the units throw rate.
Some parts of the snow thrower may freeze under extreme temperature conditions. Do not attempt to
operate the snow thrower with frozen parts. If the parts freeze while the snow thrower is in use, stop the
snow thrower, unplug the extension cord, and inspect for frozen parts. Free all parts before operating the
snow thrower. Never force controls that have frozen.
9
Publicidad
