JL Audio Fathom f113v2 Manual Del Propietário página 24

STEREO ACTIVE CROSSOVER (UNBALANCED OUTPUTS)
LOW OUT
(SUB OUT)
LEFT
ilt in USA with Imported and domestic components
F 12A H
250V
0 V ~ 60 Hz z
1200VA
WARNING! TURN OFF THE FATHOM v2 AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
EN | Pg 24
STEREO ACTIVE CROSSOVER (BALANCED OUTPUTS)
RIGHT
OR
INPUTS
Input Modes
Slave Slave Grounded
LEFT
or
MONO
Master Master Isolated
Unbalanced Balanced
Output to Slave
(Balanced)
RIGHT
ONLY
SERIAL NUMBER:
Warranty void if serial number is removed, altered or defaced.
FATHOM REAR CONTROLS (MASTER)
LOW OUT
(SUB OUT)
SYSTEM CONNECTION DIAGRAM 3:
One Fathom v2 in Mono to
Two-Channel Audio System
When connecting a Fathom v2
(or multiple Fathom v2s) in mono to
a two-channel audio system you will
use both the "Left or Mono" and the
"Right" inputs. Summing circuitry
in the Fathom v2's input section will
sum the stereo signals to mono.
We strongly recommend that you
use a high-quality active crossover,
like the JL Audio CR-1, to divide your
preamplifier's signals prior to connection
to the Fathom v2 and to the amplifier
driving your main speakers. This will
allow you to filter low frequencies out of
the signals driving the main speakers,
resulting in better performance.
If you are not using an active crossover
and are comfortable running your main
speakers full-range, you can split your
preamplifier's output signals using
appropriate Y-connectors in place of the
active crossover shown in the diagram.
Two connection types are available
for connecting the Fathom v2 to your
two-channel audio system: balanced
(XLR or 1/4-inch TRS connector) and
unbalanced (RCA-type connector).
Balanced connections provide superior
noise rejection and ensure proper
grounding between components. If your
preamplifier or active crossover offers
balanced outputs, we highly recommend
that you use them.
In the connection diagram at left,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
NOTE: If desired, additional Fathom v2s
can be connected in "Slave" mode to the
Fathom v2 connected as shown on this
diagram. See "Connection Diagram 2" on
page 23 for slave connection explanation.
WARNING
| Fathom
v2
®