JL Audio Fathom f113v2 Manual Del Propietário página 25

SYSTEM CONNECTION DIAGRAM 4:
Two Fathom v2s in Stereo to
Two-Channel Audio System
When connecting two Fathom v2s in
stereo to a two-channel audio system you
will only use the "Left or Mono" inputs of
each Fathom v2. The upper "Input Mode"
switch on each Fathom v2 will be set in
the "Master" position.
We strongly recommend that you use
a high-quality active crossover, like the JL
Audio CR-1, to divide your preamplifier's
signals prior to connection to the Fathom
v2 and to the amplifier driving your main
speakers. This will allow you to filter low
frequencies out of the signals driving
the main speakers, resulting in better
performance.
If you are not using an active crossover
and are comfortable running your main
speakers full-range, you can split your
preamplifier's output signals using
appropriate Y-connectors in place of the
active crossover shown in the diagram.
Two connection types are available
for connecting the Fathom v2s to your
two-channel audio system: balanced
(XLR or 1/4-inch TRS connector) and
unbalanced (RCA-type connector).
Balanced connections provide superior
noise rejection and ensure proper
grounding between components. If your
preamplifier or active crossover offers
balanced outputs, we highly recommend
that you use them.
In the connection diagram at right,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
NOTE: If desired, additional Fathom v2s
can be connected in "Slave" mode to each
Fathom v2 connected as shown on this
diagram. See "Connection Diagram 2" on
page 23 for slave connection explanation.
WARNING
| Fathom
v2
®
RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)
LOW OUT
(SUB OUT)
LEFT RIGHT
ilt in USA with Imported and domestic components
Input Modes
F 12A H
250V
Slave Slave
0 V ~ 60 Hz z
1200VA
Master Master
Output to Slave
ilt in USA with Imported and domestic components
Input Modes
F 12A H
250V
Slave Slave
0 V ~ 60 Hz z
1200VA
Master Master
Output to Slave
WARNING! TURN OFF THE FATHOM v2 AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
PROCESSOR (BALANCED OUTPUTS)
LOW OUT
(SUB OUT)
OR
INPUTS
Grounded
LEFT
or
MONO
Isolated
Unbalanced Balanced
(Balanced)
RIGHT
ONLY
SERIAL NUMBER:
Warranty void if serial number is removed, altered or defaced.
FATHOM REAR CONTROLS (MASTER)
INPUTS
Grounded
LEFT
or
MONO
Isolated
Unbalanced Balanced
(Balanced)
RIGHT
ONLY
SERIAL NUMBER:
Warranty void if serial number is removed, altered or defaced.
FATHOM REAR CONTROLS (MASTER)
Pg 25 | EN