Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Attach Foam Canon (stored in rear of pressure washer)
into end of lance by pressing cannon into place.It will
make a "click" sound when firmly in place.
Note: Always lock spray gun when changing the foam
cannon to ensure it does not eject with force.
• When using the foam cannon, fill it with a properly
formulated detergent or cleaner with water ratio
according to instructions on the container.
• DO NOT use thick gel-like detergents as they will clog
the foam cannon and can cause damage.
• The power washer will pull a ratio of water to
detergent of 10:1 or 10 parts water to 1 part
detergent. The detergent concentration can be
adjusted by turning the detergent knob on the top of
the cannon. Turn it left for more concentration or turn
it right for less concentration.
12
95503_IM_BC 383 HS_ENG-FR-SP(thanyou letter).indd 12
1
3
3
Operation Tips
• Note: Test the GFCI before each use:
1. Plug GFCI into power outlet. Indicator should turn
green to show that cord has power.
2. Press test button, green indicator should turn off
to verify that GFCI cut off power to the cord.
3. Press reset button – green indicator should turn
on to show that cord has power again.
4. When GFCI is working properly, green indicator
will turn on when power is applied. If green
indicator turns off, it has detected electric leakage
and the GFCI cut off power to theappliance.
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• The o-rings on the bayonet end of the nozzle lance
should be cleaned regularly and lubricated with non-
water soluble grease such as petroleum jelly.
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire,
astraightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because
the impact force of the water pressure exceeds
the durability of the surface. Bare wood can be
penetrated; paint can be peeled off, etc. You can vary
the force of your power washer by controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface being
cleaned.
• NEVER use a narrow high pressure stream of water
on soft surfaces susceptible to damage.
2020/5/22 下午3:43
Publicidad
