Publicidad
Idiomas disponibles
Idiomas disponibles
3.3VSB Standby for PCI - Jumper JP3
On: Default
3.3VSB Standby Power to
PCI slots - PCI 2.2 spec.
AGP/ADD Warning LED
The AGP slot on the NB35-EC/EL system board supports 1.5V AGP add-
in cards. If this type of AGP card is used, the AGP Warning LED will not
light. However, if no AGP card is installed in the slot or you installed a
+3.3V AGP card, the LED will light indicating that a non-1.5V card was
used.
The ADD slot on the NB60-EL/EC system board is used for installing an
ADD (AGP Digital Display) add-in card. The ADD Warning LED will not
light if an ADD card is installed in the slot. It will light if no ADD card is
installed.
DIMM Standby Power LED
This LED will turn red when the system's power is on or when it is in the
Suspend state (Power On Suspend or Suspend to RAM). It will not light
when the system is in the Soft-Off state.
PCI Standby Power LED
This LED will turn red when the system is in the power-on, Soft-Off or
Suspend (Power On Suspend or Suspend to RAM) state.
Power LED (LED 7)
This LED will light when the system's power is on.
Important:
Lighted LEDs serve as a reminder that you must power-off the
system then turn off the power supply's switch or unplug the power
cord prior to installing any memory modules or add-in cards.
2
1
Non-PCI 2.2 spec.
Quick Setup Guide
2
1
Off:
1
23
Publicidad
