Control Pannels - Sagi 3241730 Manual De Uso

All of the units have the following control panel installed:
1 2
7 8 9
3
ON/SBY key
Press this key for 3 seconds and release it as the display shows the [Sby] to
set the appliance to the stand-by mode (Backlighting activated).
When holding device in stand-by pressed [the display shows Sby], the
controller turns on (Backlighting deactivated).
ENTER key
Press and release this key to check/change the appliance temperature setpoint;
during operations the above mentioned backlighting is flashing.
UP and DOWN keys
These keys allow to increase or decrease the value of the parameter to be
changed (the backlighting is flashing during these operations).
Pressed and released enable the visualisation of the minimum and maximum
temperatures recorded (if available) and any active alarms (the backlighting is
flashing during these operations)
The button, held down for a period exceeding 3 seconds, allows the
modification of the chamber humidity settings (backlighting flashing).
Pressed at the same time for a time greater than 3 seconds enables the
selection of the keyboard lock or entry into parameter configuration by way of
the confirmation with the
DEFROST key
Pressed for a time greater than 3 seconds activates / deactivates the manual
defrost (the backlighting is activated during these operations)
LIGHT key
Pushed and released allows the activation or the deactivation of the unit's
interior illumination (backlighting ON with light ON, backlighting OFF with light
OFF), independent of the status in which the
DEFROST ICON
Led on: defrost in progress
Led blinking: defrost activation delay or dripping in progress
Led blinking at high frequency: alarm memorized
FAN ICON
Led on: room fans activated
Flashing LED: ventilator activation delay
COMPRESSOR ICON
Led on: compressor activated
Led blinking: compressor activation delay
4 5 6
button.
9

CONTROL PANNELS

POS DESCRIPTION
ON/SBY key
1
ENTER key
2
DOWN key
3
UP key
4
DEFROST key
5
LIGHT key
6
DEFROST ICON
7
FAN ICON
8
COMPRESSOR ICON
9
button might be.