Bell'O AT423B Instrucciones De Ensamble página 4

1. PLACE the left side leg (A) upright on the floor and stand at the rear of the leg . NOTE: The left frame leg (as seen
from the front) will have four "C" shape glass shelf retainer clips (Fig. 1A) facing toward the inside RIGHT side.
2. PLACE one of the two connecting crossbars (C) against the middle-top rear side of the left leg (A) and the two crossbar
mounting bracket ends facing down as shown in Fig.1, with the mounting bracket holes aligned with the two top holes
on the rear side of leg (A). INSERT two screws (F) through the holes on the mounting brackets into the left leg. SE-
CURE the screws using the supplied Allen wrench. NOTE: DO NOT FULLY TIGHTEN THE SCREWS.
3. POSITION the rear side of the right leg (B) against the front of the second mounting bracket of the top crossbar (C) and
SECURE with two screws (F) as shown in Fig.1. NOTE: DO NOT FULLY TIGHTEN THE SCREWS.
4. TURN the partially assembled Tower over so that the two top ends of the Tower rest on the floor. PLACE the
second crossbar (C) on the bottom of the metal frame making sure to ALIGN all holes. SECURE the crossbar to the
frame using four screws (F). TIGHTEN ALL FOUR SCREWS USING THE SUPPLIED ALLEN WRENCH.
5. STAND the assembled unit up-
right as shown in Fig.1 and
from the rear of the Tower,
TIGHTEN all four screws on
the top crossbar using the
Allen wrench.
6. INSERT two lock screws (E)
into each glass shelf retainer
clip using the supplied Phillips
driver as shown in
Fig. 1A. NOTE: DO NOT
TIGHTEN THE LOCK
SCREWS UNTIL THE GLASS
SHELF IS INSERTED AND IN
THE FINAL ASSEMBLY
POSITION.
7. POSITION the furniture at the
location it will occupy in the
room when fully assembled
and in use. In the event the
unit needs to be leveled on the
floor, screw or unscrew as
needed one or more of the
Tower's bottom adjustable feet
as shown in Fig.1 (!).
8. CAREFULLY insert the glass
shelves (D) through the
retainer clips on the inner
sides of the legs (A) and (B) as
shown. CENTER each shelf in
the retainer clips. TIGHTEN all
sixteen lock screws into the
glass retainer clips using the
Phillips driver. DO NOT OVER-
TIGHTEN.
NOTE: TWO PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS TOWER
E
G
C
F
!
English
Fig. 1A
F
A
C
F
H
Fig. 1
B
D
D
D
D