Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLE AND ADJUSTMENTS
Fig. 22
SWITCH
INSTALLATION:
Install the switch on
the location as Fig.23
with the hex. Screw
1/4" x 20UNC x 3/4".
Lock the screw under
the Front rail, and
make sure you have
lock including star
washer A as Fig.23.
ADJUSTING THE MITER GAUGE
See Figure 25.
You can set the miter gauge
at 0º and plus or minus 45º
with the miter gauge stop
pin and adjustable stop screws.
Note: The miter gauge provides close accuracy
in angled cuts. For very close tolerances,
test cuts are recommended.
• Loosen knob and pull out on stop pin
to rotate miter gauge base past stop screws.
• Loosen the lock nut of the 0º stop screw at
the stop pin with a 8mm wrench.
• Place a 90º square against the miter gauge
rod and the miter gauge base.
• If the rod is not square, loosen the knob,
adjust the rod, and tighten the knob.
• Adjust the 0º stop screw until
it rests against the stop pin.
• Adjust the plus and minus 45º stop screws
using a 45º triangle and the steps above.
A
Fig. 23
The table saw is equipped with a push-button switch that will
accept a padlock (not included) for locking the switch in the
OFF position. See Fig. 24. To safeguard your machine from
unauthorized operation and accidental starting by young
children, the use of padlock is necessary. Place the key in a
location that is inaccessible to children and others not
qualified to use the tool.
Miter gauge rod
Fig. 25
45º adjustable
11
Miter gauge
base
Lock nut
stop screw
Fig. 24
Knob
0º adjustable
stop screw
Publicidad
