Publicidad
Idiomas disponibles
Idiomas disponibles
KNOW YOUR MACHINE
BLADE – This saw is provided with a 64 tooth, 10 in. steel
blade. The blade is adjusted with bevel and height hand
wheels on the cabinet. Bevel angles are locked with a handle
below the front rail.
BEVEL LOCK HANDLE – This handle, placed just under the
worktable surface on the front of the cabinet, locks the angle
setting of the blade. Be sure the handle is hanging straight
down before tilting the blade. If it is not straight down, it may
jam and bend the locking bolt.
HEIGHT HANDWHEEL – Use this hand wheel to lower and
raise the blade for adjustments or replacement. It is located
on the right of the cabinet.
MITER GAUGE – This gage aligns the wood for a crosscut.
The easy-to-read indicator shows the exact angle for a miter
cut, with positive stops at 90º and 45º .
MITER GAUGE GROOVES – The miter gage rides in these
grooves on either side of the blade.
RAILS – Front and rear rails provide support for large work
pieces and the rip fence.
Riving knive 2.3 mm thick
for use with 10" blade
Body: 2.1 mm ~ 2.3 mm
Kerf: 2.8 mm ~ 3.5 mm
ASSEMBLE AND ADJUSTMENTS
ASSEMBLE THE RAISING AND TILTING HANDWHEELS
AND LOCK KNOBS
1.
Place the wheels in position over the raising and tilting
screws being sure to engage the slots, a (Fig.3), in back
of each wheel with the roll pins, b (Fig.3), as shown at
right.
2.
Screw on lock knobs c (Fig.4), to hold wheels in place,
then attach silver handles, d (Fig.4) tightening them with
the supplied 12mm combination wrench.
3.
To use rising and tilting wheels, loosen lock nuts (but not
too much or roll pins will disengage from slots), turn
wheels to desired position and retighten lock nuts. Do
not operate saw with lock nuts untightened as the blade
could move out of position.
RIP FENCE – A sturdy metal fence guides the workpiece and
is secured with the rip fence handle.
Grooves run along the top and sides of the rip fence for use
with optional clamps and accessories.
RIP FENCE HANDLE – The handle on the front of the rip
fence releases the rip fence or locks it in place.
RIVING KNIFE OR SPREADER – Located directly behind
the blade, it keeps cut edges from binding and supports the
blade guard.
SCALE – Found on the front rail, the easy–to–read scale pro-
vides precise measurements in rip cuts.
EXTENSIONS WINGS – Removable stamped steel exten-
sions, 12 in. By 27 in., support larger work pieces.
WARNING
1. Be sure to use only blades rated for at least
2. Please use the standard blade according to
Fig. 2-2
Spreader 2.3 mm thick for
use with 10" blade
Body: 2.1 mm ~ 2.3 mm
Kerf: 2.8 mm ~ 3.5 mm
6
4,200 r.p.m. and recommended for use on this saw.
the specification mark on the blade as
Fig.2-2 & Fig.2-3:
a
Fig. 2-3
b
Fig. 3
Publicidad
