Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING DIAGRAMS
When rewiring the supplied electric motor, be sure power cord is unplugged then change the connection
as illustrated below. Always secure wire nuts with friction tap. A new plug will be required.
NOTE: The reconnection shall be made by qualified electrician or service personnel.
1. TO 110 VOLT. Open motor
wire box, contact No.1 red
motor wire and No.3 yellow
motor wire to either power
wire; than contact No.2
black motor wire and No.4
white motor wire to another
power wire. Please refer to
Fig. 1.3.
2. TO 220 VOLT. Open motor
wire box, contact No.1 red
motor wire to either power
wire, and contact No.4
white motor wire to another
power wire, than contact
No.2 black motor wire to
No.3 yellow motor wire.
Place refer to Fig.1.4.
GLOSSARY OF TERMS FOR WOODWORKING
Anti-Kickback Pawls: Toothed safety devices behind the
blade designed to stop a workpiece from being kicked back
at the operator during a ripping operation.
Arbor: The shaft on which a blade or cutting
tool is mounted.
Bevel Cut: A cutting operation made with the blade at any
angle other than 90°to the saw table.
Compound Cut: A cut with both a miter angle and a bevel
angle.
Crosscut: A cutting operation made across the grain or the
width of the workpiece.
Dado A non-through cut that gives a square notch or
though; requires a special blade.
Feather board: A device to help guide workpieces during
rip cuts.
Freehand (for Table Saw): Dangerous practice of making a
cut without using rip or miter fences. See Safety Rules.
Gum: A sticky, sap-based residue from wood products.
Heel: Alignment of the blade.
Kerf: The material removed by the blade in a through cut or
the slot produced by the blade in a non-through cut.
Kickback: A hazard that can occur when blade binds or
stalls, throwing workpiece back toward operator.
Leading End: The end of the workpiece pushed into the cut-
ting tool first.
Miter Cut: A cutting operation made with the miter gage at
any angle other than 0°.
110 V
220 V
Molding: A non-through cut that gives a varied shape to the
workpiece and requires a special blade.
Push Stick: A device used to feed the workpiece through
the saw blade during narrow cutting operations. It helps
keep the operator's hands well away from the blade.
Rabbet: A notch in the edge of a workpiece.
Re saw: A cutting operation to reduce the thickness of the
workpiece in order to make thinner pieces.
Resin: A sticky, sap-based substance.
Rip Cut: A cut made with the grain of the workpiece.
Saw blade Path: The area directly in line with
the blade –over, under, behind, or in front of it. Also, the
workpiece area which will be or has been cut by the blade.
Set: The distance that the tip of the saw blade tooth is bent
(or set ) outward from the face of the blade.
Throw-Back: Saw throwing back a workpiece; similar to
kickback.
Through Sawing: Any cutting operation where the blade
extends completely through the workpiece.
Trailing End: The workpiece end last cut by the blade in a
rip cut.
Workpiece: The item on which the cutting operation is being
done. The surfaces of a workpiece are commonly referred to
as faces, ends, and edges.
Worktable: The surface on which the workpiece rests while
performing a cutting operation.
4
Red
Yellow
Black
White
Fig.1.3
Red
Yellow
Black
White
Fig.1.4
1
3
2
4
1
2
3
4
Publicidad
