Stanley FATMAX FMHT82565-0 Manual De Instrucciones página 10

EN
User Manual
Direct current measurement
1
Place the black probe into the "COM" jack. for current to be
measured not exceeding 200mA, put the red one into the
"VΩmA" jack. For current to be measured between 200mA and
10A, insert the red probe into the "10A" jack.
2
Set the function/range switch to the desired "
connect the probe in series with the load to be measured. The
current value and the polarity connected to the red probe will be
shown on the display.
1. If you do not know the measured current range in advance, set the function/
range switch to the maximum range, and then gradually turn to smaller
ranges until satisfactory resolution.
2. If the display shows "OL", this indicates an overrange measurement, and the
switch should be set to a higher range.
3. The symbol "
is 200mA or 10A, depending on the inserted jack Overcurrent will blow the
fuse.
1
Place the black probe into the "COM" jack and the red one into
the "VΩmA" jack.
2
Turn the function/range switch to the "COM" jack, and connect
the probe to the resistor being measured and read the results on
the display.
1. If the resistor being measured is greater than the maximum value of the
selected range, the display will show "OL", requiring the selection of a higher
range. It normally takes a few seconds for the reading to get stable when
measuring a resistor larger than 1 MΩ.
2. In default of input, for instance, open circuit, the display shows "OL".
3. When measuring an online resistor, de-energized the circuit being measured
and discharge all capacitors.
10
WARNING
" beside the probe indicates the maximum input current
WARNING
" range, and