Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE BRUSH CUTTER
CHOOSING THE CUTTING DEVICE
Choose the most suitable cutting device for the job to be done, according to these general
indications:
The cutting line head can eliminate tall grass and non-woody vegetation
The 3-point blade is suitable for cutting brushwood and small shrubs up to 2 cm in diameter.
CUTTING LINE HEAD
Cut the grass in 1.5 metre widths, keeping the machine well balanced.
Avoid engaging stones, piles of earth, small pieces of wood or anything that could be hidden or difficult to
see in the grass. If a large object is accidentally struck, if the cutting head gets blocked, overloaded or
stringy material gets wrapped in the cutting head: reduce the engine speed so the engine idles. Make
sure that the cutting head has stopped rotating switch off the engine and remove the material.
Put the grass trimmer on the ground and check that the cutting head has not been damaged. If
necessary, change the cutting head. If the head is only wrapped by vegetation, remove by hand and
clean the cutting head.
Always wear safety gloves for this operation and ensure the engine is switched off and the head is
stationary.
When the 2 nylon cords become too short, accelerate the engine and bump the nylon head on the
ground. Automatically the 2 nylon cords will feed out and be cut to the correct length. Repeat the
operation if necessary.
3-POINT BLADE
Start cutting above the undergrowth and then move down with the blade so as to cut the brush into small
pieces.
Avoid hitting stones, piles of earth, small pieces of wood or anything that could be hidden or difficult to
see in the grass.
FUEL FILTER
Every 15 hours of operation using a wire hook, take the fuel filter from the fuel tank Fig16 and clean or
replace with a new fuel filter.
Fig 16
fuel filter
SPARK PLUG
Poor starting or misfiring is often caused by a fouled or defective spark plug, clean and reset the
gap to 0.65 mm, or replace the spark plug with NGK: BPRM7A as necessary Fig 17.
Fig 17
13（GB）
Publicidad
