Publicidad
Checking the LED Indicators
When the AP is connected to power, LEDs indicate activity as follows:
Indicator
LED 1
(Power/
System)
LED 2
(2.4G)
LED 3
(5G)
LED 4
(Ethernet)
3 Connecting to the AP
To connect to the AP, you must first determine the AP's IP address in one of these
ways.
Finding the IP Address on Networks with a DHCP Server(FIT AP)
If your network has a DHCP server, it automatically assigns an IP address to the AP.
Finding the IP Address on Networks Without a DHCP Server(FAT AP)
If your network does not have a DHCP server, the AP uses a default factory
configuration which includes the following information.
Configure the IP address of the AP as 192.168.0.50.
Configure the AP to enable the Telnet server function (the default
authentication username is admin, password is password, case sensitive).
You can remotely manage and maintain the AP through Telnet.
Log into the AP
To Log into the AP after you determine its IP address, follows these steps:
Color
State
Off
On
Amber
Blinking
Green
On
Off
Green
On
Blinking
Off
Green
On
Blinking
Off
Amber
On
Blinking
On
Green
Blinking
Description
No power
Failure of CPU or system
System initiation or reset (software self-
testing and loading)
Powered on and ready for operation
Radio disabled
Radio enabled
Activity
Radio disabled
Radio enabled
Activity
No 10/100/1000 BASE-T link detected, or
administratively disabled
10/100 BASE-T link detected; no activity
10/100 BASE-T link activity
1000 BASE-T link detected; no activity
1000 BASE-T link activity
9
Publicidad
