Publicidad
: RJ-45 ports. These are RJ-45 data sockets. They cannot be used as
standard traditional telephone sockets, or to connect the unit to a traditional PBX or
public telephone network. Only connect RJ-45 data connectors, network telephony
systems, or network telephones to these sockets.
Either shielded or unshielded data cables with shielded or unshielded jacks can be
connected to these data sockets.
: To comply with FCC radio frequency (RF) exposure limits, a minimum
body-to-antenna distance of 20 cm must be maintained when the AP is operational.
Approved Channels
Use of this product is only authorized for the channels approved by each country. For
proper installation, select your country from the country-selection list.
To conform to FCC and other country restrictions, your product may be limited in the
channels that are available. If other channels are permitted your country, please visit
the web site for the latest software version:
http://www.3com.com
2 Mounting the AP
Unpacking the AP
Make sure that you have the following items, which are included with the AP:
One 3Com 9552 Access Point
Wall-mounting hardware:
One combined wall-mounting bracket and table-top stand
Four screws
Four wall anchors
Suspended ceiling bracket:
One ceiling bracket
One slider
Two screws
Eight adhesive rubber feet
One copy of this Quick Start Guide
One 3Com Warranty Flyer
One console cable
3
Publicidad
