English
Owner´s manual
Wood chipping
NOTICE: Woods' and branches' diameter should be no bigger than 120mm.
WARNING:
•
Do not place your hands into the chute when loading. This is a very UNSAFE method and
could result in injury to your hands.
•
Do not reach or step across the rail while the Wood Chipper is running. This is a very UNSA-
FE method which could cause personal injury, even death.
When Blocked
If the Roller stops while chipping woods or branches, the engine should be stopped, and take
out the woods which stuck the roller, and then restart the engine, and chip again.
4. MAINTENANCE
Regular maintenance is the way to ensure the best performance and long life of your machi-
ne. Please refer to this manual and the engine manufacturer's user manual for maintenance
procedures.
WARNING: Before performing any maintenance procedure or inspection, stop the engine,
wait five minutes to allow all parts to cool. Disconnect the spark plug wire, keeping it away from
the spark plug. Disconnect the Battery Terminals (Electric start only -DWS150E-).
Regular Maintenance Checklist
Procedure
Check engine oil level
Check general equipment
condition
Check that the blade is sharp
Grease sliding guide surface
Check belts
Grease the belt pinion system
Check tire pressure
Clean engine exterior and
cooling
Change Engine Oil
Replace air filter
Replace spark plug
22
Before each
Every 3 h.
use
•
•
•
•
•
First time after 5
hours of use
Every 25 h.
•
•
•
•
•
Every 100
h.
•