Publicidad
Part Names
REMOTE CONTROLLER
1 remote controller can control a group of up to 8 indoor units.
1. Operation Display
Displays the operation status. (The
figure shows all the statuses.)
2. Start/Stop button
Pressing this button once starts and
pressing again stops the operation.
3. Fan speed button
Press to change the fan speed.
4. Flap button
Press to change the flap direction.
5. ECONAVI button
Press to set ECONAVI.
6. nanoe™ X button
Press to set nanoe™ X.
7. Ventilation button
Use this when connected to an
aftermarket fan.
8. Clock button
Use this to set the clock.
9. Cover
Press at the top center and then slide
down.
10. Transmitter
1
2
3
4
5
6
7
8
9
11. Temperature setting buttons
12. Mode select button
13. Energy saving button
14. Filter button
ECONAVI
nanoeX
15. Timer setting buttons
16. RC reset button
17. RC address button
10
11
12
13
14
15
16
17
raises the temperature setting
1 °C at a time.
lowers the temperature setting
1 °C at a time.
Press to switch the operation mode.
Press to enable or disable energy
saving.
Press to turn off the filter lamp on the
receiver.
/
/
/
Use for operating with a timer.
Use this button after changing the
batteries.
Press to set addresses.
From this page, the names of
remote controller's buttons will be
indicated with the above illustrations.
E.g.: Start/Stop button
/
/
RC
RESET
RC
ADR
5
Publicidad
