Publicidad
Idiomas disponibles
Idiomas disponibles
English
(2)
Release the locking lever (A) as shown in the
diagram, raise the LED unit approximately
12" (30 cm), then lock the locking lever (A) in
place again. Now adjust the lens angle. (Figs.
11, 12)
Extension pole
Locking
Unlock
lever (A)
Locking
lever (B)
120°
(3) After adjusting the angle, release the locking
lever (A), and raise the LED unit to the desired
height. Once in the desired position, lock the
locking lever (A) in place again. If the unit is too
low, release the locking lever (B), and extend
as necessary.
WARNING
●
Be sure to keep the locking levers locked
except when you are adjusting the height.
●
To prevent injury, retract the pole when not
in use.
NOTE
Turn off the light before adjusting the LED unit
angle.
16
LED unit
Storage
Lock
cover
Fig. 11
215°
LED unit
230°
120°
Fig. 12
2.
Turning the light on (Fig. 13)
Press the switch to turn the light on.
Pressing the switch toggles the brightness (in
the sequence of Max, High, Mid, Low) before
turning off the light completely.
Holding down the switch turns off the light
regardless of its brightness.
The light will remain at that brightness level the
next time it is turned on.
When the battery level is low, the light will blink
three times approximately every minute. If this
occurs, either replace the battery or connect
the AC adapter.
Switch
4.
Retracting the tripod light
WARNING
Be careful not to pinch your hands
or fi ngers in the sliding parts during
operation. (Fig. 14)
Fig. 13
Fig. 14
Publicidad
