Publicidad
Idiomas disponibles
Idiomas disponibles
FREQUENTLY ASKED QUESTIONS/ TROUBLESHOOTING
Question/problem - cause
Cause
The angle grinder does not run or runs at low speed:
• The compressor is switched off;
• The shut-off valve of the compressed air system is closed;
• Low air pressure;
• Leaked air hose;
• The air inlet filter is clogged;
• The angle grinder has signs of moisture;
• The ON/OFF switch is locked;
• Inadequate or non-existent lubrication;
The appliance overheats during operation:
• Inadequate or non-existent lubrication;
• Incorrectly assembled parts;
WARRANTY CERTIFICATE
The warranty of this air angle grinder is two years from the date
of purchase.
You should, therefore, keep your proof of
purchase during this period. The warranty covers any
manufacturing defect in material or operation, as well as parts
and work needed for their recovery.
Excluded from the warranty are the misuse of the product, any
repairs carried out by unauthorized individuals (outside the
service center of the brand VITO) as well as any damage caused
by the use of it.
30
Solution
• Switch on the compressor;
• Open the shut-off valve;
• Increase the pressure on the air filter regulator lubricator;
• Replace the air hose;
• Clean the filter;
• Drain the pressure regulator cup;
• Ensure free movement of the "ON/OFF" switch;
• Grease properly;
• Grease properly;
• Ensure parts are properly assembled and tightened;
DECLARATION OF CONFORMITY
We declare, under our sole responsibility, that the product
labelled 100MM PNEUMATIC ANGLE GRINDER with code
VIRP100 complies with the following standards or normative
documents: EN ISO 12100:2010, EN ISO 11148-6:2013, EN ISO
11148-5:2012 e EN ISO 11148-7:2012, as defined by:
2006/42/EC - The Machinery Directive
S. João de Ver,
30th june 2021
Central Lobão S. A.
Technical supervisor
Hugo Santos
Publicidad
