Publicidad
Step 3
å
Separate the SMALL EXTENSION SLIDES (4) from the SMALL EXTENSION RAILS (3) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten two SMALL EXTENSION RAILS (3) to the ENDS (E and F). Use six BLACK 7/16" FLAT HEAD SCREWS (20).
through the holes shown.
å
NOTE: For each SMALL EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the END. Turn a SCREW into
these holes.
å
NOTE: The SMALL EXTENSION SLIDES will be used later for the DRAWERS.
Open end
3
Open end
423742
4
Groove
3
E
www.sauder.com/service
hole shown in the diagram. Then, slide the inner
st
1
st
3
Use these holes.
Groove
F
3
Open end
BLACK 7/16" FLAT HEAD SCREW
(6 used in this step)
hole
20
Page 7
Publicidad
