Publicidad
Step 4
å
Separate the LARGE EXTENSION SLIDES (2) from the LARGE EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the LARGE EXTENSION RAILS (1) to the ENDS (E and F). Use six BLACK 7/16" FLAT HEAD SCREWS (20).
through the holes shown.
å
NOTE: For each LARGE EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END. Turn a SCREW into
these holes.
å
NOTE: The LARGE EXTENSION SLIDES will be used later for the DRAWERS.
Open end
1
Open end
Page 8
2
E
1
Open end
www.sauder.com/service
hole shown in the diagram. Then, slide the inner
st
1
Use these holes.
1
F
BLACK 7/16" FLAT HEAD SCREW
(6 used in this step)
1
hole
st
Groove
Groove
20
423742
Publicidad
