Publicidad
Idiomas disponibles
Idiomas disponibles
Keep warning and information stickers always clean and
legible.
Keep all nuts and screws well tightened in order to
ensure a safe operation.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately.
Storage in case if longer stopping periods
Never store the device with petrol in the tank inside a
building. Petrol vapours may come into contact with
flames or sparks and ignite.
Store the brush cutter in a dry area with the fuel tank
empty and the fuel in a well-ventilated compartment.
Avoid places with high humidity to avoid the
appearance of corrosion and rust.
Clean the equipment thoroughly before storage,
especially in winter. Keep the device in a good operating
mode.
Make sure the device is protected against misuse (for
example, by children).
Technical assistance
Your brush cutter should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
ASSEMBLY INSTRUCTIONS
Handle
1. Unscrew the 4 screws and remove the handle bracket
cover;
2. Place the handle on the bracket;
3. Put the cover back on and tighten the 4 screws;
Guard
The guard avoids the projection of loose objects and
accidental contact of the cutting accessories with the
user.
The guard should always be installed when using
the nylon line reel. It should be removed when
using the grass cutting blade.
1. Attach the blade/guard to the spindle and tighten
with two screws;
2. Insert the guard into the groove;
3. Then press it into position with the strips;
4. The guard is easily removed using a screwdriver.
The guard does not protect the user against all
objects (stones, glass, wire, etc) that are projected
by the cutting accessory. These objects can bounce off
any surface and hit the user.
Blade
Check the state of the blade before installing it to the
appliance. If it is damaged (cracked, bent or broken)
replace it.
1. Place the upper support flange on the output shaft;
2. Turn the blade spindle until the hole in the upper
support flange is aligned with the corresponding hole in
the top of the head;
3. Insert the locking pin into the hole to lock the shaft;
4. Place the blade, lower support flange and head base
on the output shaft;
5. To tighten the nut, turn the wrench in the opposite
direction of rotation.
6. Remove the locking pin after having completed
installation.
Mowing head with nylon line
1. Place the upper support flange on the output shaft;
2. Turn the blade spindle until the hole in the upper
support flange is lined up with the corresponding hole
in the upper protective cover;
3. Insert the locking pin in the hole to lock the shaft;
4. Screw into the mowing head in the opposite
direction to the direction of rotation;
Placing the mowing head with nylon head
1. Press the locking tabs and remove the mowing head
cover;
2. Remove the reel from the cover and remove the
existing line;
3. Prepare about 5m of nylon line and fold it in half;
4. Fix the line in the groove of the central spacer of the
reel;
5. Wind the two ends in parallel, one on each side of the
central spacer, clockwise (arrow shown on the reel);
6. Attach the ends of the line to the outer fixing grooves
of the reel;
7. Insert the reel into the mowing head cover;
8. Release the line from the fixing grooves and insert the
ends of the line into the grooves of the cover;
9. Place the mowing head cover;
39
Publicidad
