Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Cover the front grill and tighten with screws on it.
3. OPERATION
•
Before using the fan make sure that it is on a flat and stable surface. Damage may occur if
it is placed on an incline or decline.
•
Set all the switches to OFF position, then insert the plug directly into a standard socket-
outlet. Be sure plug fits tightly into outlet.
1.
Press the button
the default speed setting is 18.
2.
Press the button
normal wind – nature wind – sleeping wind – normal wind. The wind mode selecting can be
circulated and the wind mode pilot lamp will be on during the fan operating.
3.
Set the timer by pressing the button
1 to 18 hours. The pilot light corresponding to the selected timing level will be illuminated.
4.
If you want to enlarge blast area in your room, press the button
press this button again, the pilot light will go out.
Rotate the control knob beside the control panel, you can change the fan speed. Rotate the knob
clockwise to increase the speed, and rotate the knob anti-clockwise to decrease the speed.
Note: all above functions can be operated from the remote control.
4. CLEANING AND MAINTENANCE
1.
Always remove the plug from the socket-outlet and allow the fan to stop acting before
clean the fan.
2.
Clean the external surfaces of the fan with a soft damp (not dripping wet) cloth.
WARNING:
•
Do not immerse the fan in water.
•
Do not use any cleaning chemicals such as detergents and abrasives.
•
Do not allow the interior (special for the PCB) to get wet as this could create a hazard.
3.
When the unit is not in use, make sure that it is unplugged from the wall socket. To store the
to start and turn off the fan, the default mode setting is normal and
to choose your desired wind mode as per the following sequence:
to select a desired timing level, the range is from
FORCESILENCE 1030/1040 EXTREMEFLOW
ENGLISH
; to stop oscillating, just
15
Publicidad
