Publicidad
Idiomas disponibles
Idiomas disponibles
4.1
START THE MACHINE
2
1. Connect the machine into an approved outdoor extension
cable.
2. Push and hold the start button (2).
3. While you hold the start button, pull the bail switch (1) in
the direction of the handle bar.
4. Release the start button to start the machine.
4.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the cylinder fully stops before you start the
machine again. Do not quickly turn the machine off and on.
WARNING
Always disconnect from the power supply after you
complete the work.
English
4.3
USE THE CORD RETAINER
1
In the condition that the extension cable disconnects from the
power supply during operation, the machine contains a cord
retainer. The cord retainer hangs from the cord guide bar.
Make a loop of the extension cable around the cord retainer
before we connect the extension cable into the outlet.
To use the cord retainer:
1. Make a tight loop near the cord retainer.
2. Push the loop through the bottom hole in the cord
retainer.
3. Move the loop over the retaining clip, and pull down until
the cable attaches to the cord retainer.
4.4
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Disconnect the machine from the power supply.
3. Open the rear discharge door and hold it.
4. Hold the grass catcher by its handle and unhook it from
the slots.
5. Close the rear discharge door.
6. Empty the grass catcher.
9
NOTE
EN
Publicidad
