Sauder Costa Serie Manual Del Usuario página 17

Step 11
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT END (A) until the
shoulders of the SCREWS rest on the surface of the RIGHT END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide one END MOLDING (F) onto the RIGHT END (A). Line up the groove in the
MOLDING over the heads of the SCREWS in the RIGHT END.
å
NOTE: The MOLDING should be even on both edges of the RIGHT END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
www.sauder.com/service
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
A
430237
32S
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
F
Page 17