Starting And Stopping; Check Before Starting - McCulloch T26CS Manual De Instrucciones

S1156009-38,T26CS_1.fm Page 14 Wednesday, April 6, 2016 1:15 PM

Check before starting

• Check that the trimmer head and trimmer guard are
not damaged or cracked. Replace the trimmer head or
trimmer guard if they have been exposed to impact or
are cracked.
• Never use the machine without a guard nor with a
defective guard.
• All covers must be correctly fitted and undamaged
before you start the machine.

Starting and stopping

WARNING! The complete clutch cover and
!
shaft must be fitted before the machine is
started, otherwise the clutch can come
loose and cause personal injury.
Always move the machine away from the
refuelling area and source before starting.
Place the machine on a flat surface.
Ensure the cutting attachment cannot
come into contact with any object.
Make sure no unauthorised persons are in
the working area. Otherwise there is a risk
of serious personal injury. The safety
distance is 15 meters.
Starting
Cold engine
NOTE!
To minimize load on engine during starting and warm-up,
trim excess cutter line to 13 cm.
• Choke: Your unit is designed with a 3 position choke:
Full choke, half chokeand Run position. Set the choke
control in the choke position.
14 – English
STARTING AND STOPPING
•
•
•
•
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Squeeze throttle trigger in full position.
WARNING! When the engine is started
!
with full throttle the cutting attachment
will start to rotate immediately.
Primer bulb: Press the air purge 10 times.
x10
Wait 10 seconds.
Make quickly and powerful pulls with the starter
handle, max. 6 times. Never twist the starter cord
around your hand.