Publicidad
Idiomas disponibles
Idiomas disponibles
5.2
Setting the temperature unit
A video on this topic is provided under the following link
www.renfert.com/simplex-3-en
⇒ Select the SETTINGS menu.
⇒ Use the right arrow
⇒ Press the button with the temperature icon
⇒ The unit can be changed by pressing the arrow buttons
The factory setting is °Celsius.
⇒ Press the lower left arrow
5.3
Wi-Fi connection
A video on this topic is provided under the following link
www.renfert.com/simplex-8-en
The Wi-Fi module is only available in EU member states and in the USA.
The button with the Wi-Fi icon
is available.
The Wi-Fi module may only be used as an information tool for monitoring
printing. Print jobs cannot be started, paused, or stopped using the Wi-Fi
module.
⇒ Select the SETTINGS menu.
⇒ Use the right arrow
⇒ Press the button with the Wi-Fi icon
⇒ Press the button with the search icon
♦ A list of Wi-Fi networks is shown
⇒ Use the up/down arrows
the checkmark
⇒ Enter the password of the selected Wi-Fi network.
⇒ Confirm the password using the checkmark
A connection was successfully established to the selected Wi-Fi network:
♦ The name of the connected Wi-Fi network is shown
♦ The IP address (LAN IP) allocated for the SIMPLEX 3D filament printer is
shown�
A connection could not be established to the selected Wi-Fi network:
♦ An error message is shown:
"No connection to host <Name of the WiFi network>"
⇒ Press the lower left arrow
and via the QR code shown.
�
to go to page 2 (as shown here in the image).
until you are back in the main menu�
and via the QR code shown.
can only be operated if the Wi-Fi module
�
to go to page 4 (as shown here in the image).
�
to search for a Wi-Fi network.
/
and select the required Wi-Fi network using
�
until you are back in the main menu�
- 11 -
�
/
at the top�
�
en
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Publicidad
