Descargar Imprimir esta página

resideo Braukmann FK06-101-DUS-LF DialSet Instrucciones De Instalación página 3

Combinación del filtro regulador de presión sin plomo
Ocultar thumbs Ver también para Braukmann FK06-101-DUS-LF DialSet:

Publicidad

Idiomas disponibles

Idiomas disponibles

• Spring bonnet with setting knob and scale
• Adjustment spring
• Fine filter in clear filter bowl
• Ball valve
OPTIONS
FK06-...DUT = with clear filter bowl, threaded
union connectors, filter mesh size 50 μm
FK06-...DUS = with clear filter bowl, sweat
union connectors, filter mesh size 50 μm
ASSEMBLY
Installations Guidelines
When Installing this Product...
1. Read these instructions carefully. Fail-
ure to follow them could damage the
product or cause a hazardous condi-
tion.
2. Check the ratings given in these
instructions and on the product to
make sure the product is suitable for
your application.
3. Installer must be a trained, experienced
service technician.
4. PRV should be installed in an accessi-
ble location for maintenance, repair, or
replacement.
5. After installation is complete, check out
the product operation as provided in
these instructions.
It is necessary during installation to follow
the installation instructions, to comply with
local requirements and to follow the codes of
good practice.
• Install in horizontal pipework with filter
bowl downwards
This position ensures optimum filter
efficiency
• Install shutoff valves
• Ensure good access
Degree of contamination can be eas-
ily seen with clear filter bowl
Simplifies maintenance and inspec-
tion
BRAUKMANN FK06 DIALSET®
• The installation location should be
protected against frost.
Assembly Instructions
It is recommended to install an inlet non-
return valve.
IMPORTANT
When using soldering connections,
do not solder the connections
together with the filter combination.
High temperature will irreparably
damage important internal working
components.
1. Thoroughly flush pipework.
2. Fit filter combination.
• Note flow direction (indicated by
arrow).
• Install without tension or bending
stresses.
3. Set outlet pressure.
Drain for rinse water
The rinse water must be piped to the drain in
such a way that no back pressure can occur.
1. Discharge into drain connector.
2. Discharge into floor drain.
Fig. 1. Drain for rinse water.
3
C
M36609
38-00059EFS—11

Publicidad

loading