NORAUTO N20 Manual página 47

The jack remains
locked in the upper
position when
under load.
After each maintenance or repair, the markings must be checked to ensure
that they are identical to the original markings.
DISPOSAL
Dispose of the jack at a recycling centre or a collection point in your city/
municipality.
DISPOSAL OF LUBRICANTS, CLEANING AGENTS, AND USED OIL
IMPORTANT: Lubricants, cleaning agents and used oil from the hydraulic
system must not be disposed of in household waste, in the sewage system
or outdoors!
Dispose of lubricants, cleaning agents and used oil at a recycling centre or
a collection point in your city/municipality.
Warning
Wear work shoes
Secure the load with blocks before starting work on or under the
vehicle.
Release the pressure by loosening the valve with
the supplied handle. If it is not possible to loosen the
valve with the handle, use a wrench (not included).
If the jack cannot be lowered, tighten the valve and
move the jack up and down (pump) to complete an
additional 10 pumping movements. Then try to lower
the pressure again by loosening the valve. Warning:
Avoid loosening the valve after more than three
consecutive cycles. If the aforementioned measures
are ineffective, use other approved lifting devices to
lift the load. Remove the defective jack and consult a
qualified workshop.
Use wheel chocks to fix the
vehicle in place.
Use wheel chocks to fix the
vehicle in place.
EN
46