Publicidad
Idiomas disponibles
Idiomas disponibles
7. CONNECTION TO THE MAINS
1.
Ensure that the current and frequency of the mains supply are the same as those indicated on the label attached on the back
of the appliance
. 2.
Ensure that the supply socket has the following characteristics: a) it is properly earthed. b) It is
appropriate for the nominal current as set out on the rating plate. c) It complies with the IEC regulations: magnetothermic
switch with In = nominal value as stated on the rating plate. Differential switch with sensitivity = 30 mA. . Ensure that there
is no danger of explosion (AD).
transport or storage, the appliance has been erroneously placed in horizontal position or upside-down, leave it in the correct
vertical position for at least 3 hours before connecting it to the electrical supply. . Insert the plug into the socket (do not use
triple or adapter).
6.
Press the switch to the refrigeration unit until the green light is lit up. The switch is placed in the lower
left part, behind the front grille (To remove the grille, see chapter 10) (See picture 5).
8. CONTROLS
The controls of the appliance are situated in a protected panel, which is placed behind the front grille, at the bottom on the left
(To remove the grille, see Chapter 10).
rectangular recess. . 1
Refrigeration unit switch:
temperature inside the appliance.
the temperature: pushing once the button
several times the button
temperature decreases
9. CHECKING CORRECT FUNCTIONING
CHECK THAT: 1.
The appliance is plugged in.
3
. The lights are switched on. . The thermometer shows a suitable temperature for the goods to be stored. . The appliance is
not exposed to the direct light of the sun or high powered lamps.
the appliance is designed to work normally, i.e.+25°C U.R.60% (climatic class 3).
is correctly loaded, without excessive weight on any of the shelves (Max Kg 10 per shelf), and leaving enough space to allow
the cold air to circulate correctly.
10. CLEANING THE CONDENSER
1.
Use the main switch to switch off the power supply and then remove the plug from the wall socket. . Remove the grille
fastening screws. . Remove the grille in the direction showed in the picture. . With a brush remove the dust layer from the
3
5
condenser's fins. . Use a vacuum cleaner to remove the remaining dust. . Replace the grille and switch on the power supply
(see picture 7).
11. REPLACEMENT OF THE LAMPS
1
. Switch off the electrical supply as in Chapter 10. . Remove the protection of the fluorescent tube, simply slipping it off
3.
downwards.
Take the fluorescent tube and rotate it of 90 degrees until the release. . Remove the fluorescent tube
downwards.
5.
Replace the fluorescent tube. . Replace everything in reverse order (see picture 8).
4.
The supply cable to the appliance is H05 VVF, designed for internal use.
The controls of the appliance are situated at the front inside a protected
Thermostat:
to adjust the temperature inside the appliance. In order to adjust
4 "SET"
5 "UP"
the temperature increases while pushing several times the button
(see picture 6)
2.
The refrigeration unit switch is switched on with the green light lit up.
4
(SKILLED PERSONNEL ONLY )
2
6
5
to run the refrigeration system. .
the display will show the temperature of the cell, pushing
6.
The ambient temperature does not exceed that in which
4
6
9
3
Notice:
3 Thermometer:
6 "DOWN"
5
7.
Make sure that the internal compartment
2
4
If during
to read the
the
Publicidad
