GYS NOMAD POWER PRO TRUCK Manual De Instrucciones página 12

Translation of the original instructions
Jump Start Vehicle Instruction
Do not start a Lithium LiFePO4 battery with this booster as it is equipped with a Lithium NMC battery
whose voltage is not compatible.
!
Recharge the NOMAD POWER before first use and after each use.
1. Make sure the numbers LCD Display is not less than 40%.
2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BLACK clamp to the vehicle's
battery negative (-) terminal.
3. When jump start 12 V car host displays «12V JUMP START READY», when jump start 24 V car, host displays «24V
JUMP START READY»,
4. Start the vehicle.
Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating.
Give two minutes between attempts.
The jumping cable may overheat. In this case a protection system cuts the tension at the
clamps.
5. When the vehicle is started, remove the jumper cable from Jump Starter
clamps from the vehicle battery. Leave the vehicle's engine running.
After jump start the car,don't charge this unit immediately.
Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it
could lead to damage.
USE IN FORCED START MODE
When the vehicle battery is too discharged, the NOMAD POWER cannot start.
The NOMAD POWER PRO TRUCK is equipped with a function to force start.
Make sure that the clamps are correctly connected to the positive and negative poles of the vehicle battery. If they are
not connected correctly, the booster will not supply the vehicle battery.
The forced start mode disables the booster protections.
Check the connections before switching to this mode.
DO NOT REVERSE THE POLARITY.
12
NOMAD POWER PRO TRUCK
and disconnect RED and BLACK
11
EN