Blackstone 1554 Manual Del Propietário página 13

TroUBLESHooTInG
Model 1554
Section 01
BAT TERY POWERED IGNITION
S T E P 0 6
Place the grease cup on
SYMPTOMS
the back of the griddle body in the
01. Burner will not Light with ignition system
center of the unit.
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
S T E P 0 7 With the help of another person, place the griddle top onto
the griddle body by aligning the four pins to the holes on top of the body.
Make sure the pins are fully seated in the holes.
If you CAN ignite your griddle with a match
Insert one AA battery (not included) into the battery socket beneath the
Ignition Button.
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Ignitor wire misaligned.
04. Damage to the ignition system.
If you CAN NOT ignite your griddle with a match
S T E P 0 8
Use two (2) M6x38
POSSIBLE CAUSES
screws to attach the upper propane
tank hanger. Use two (2) M6 lock
05. Burner tubes are not receiving fuel.
nuts to secure it from the back.
Then, use two (2) M6x38 screws
to attach the lower propane tank
hanger. Use two (2) M6 lock nuts to
secure it from the back.
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
Assembly Guide | Owner's Manual
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
3-7mm
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
09