Atlas Copco LBB16 EP024-U Manual De Instrucciones página 7

LBB16 EP024-U
This can be prevented by flushing with oil (a few drops), running the tool for 5–
10 seconds and absorbing the oil in a cloth. Protect the tool this way before
longer standstills.
Overhaul and lubrication
The tool should be checked regularly at six-monthly intervals. If it is in heavy
duty service or not running properly, it should be taken out of service more of-
ten for inspection.
Regarding instruction for dismantling and assembly, see separate Service Man-
ual.
The throttle valve, planetary gears, needle bearings and ball bearings must be
lubricated with grease when the tool is dismantled for the regular overhauls.
Molykote BR2 Plus gives long intervals between lubrications.
Clean the motor parts and apply a thin layer of air lubrication oil onto the
vanes and inner surface of cylinder and end plates.
Assemble the motor and check that it is running free. Add two drops of oil
through the air inlet and run the motor (machine) at idling speed for 5-10
seconds.
The strainer in the adapter should be cleaned regularly to prevent choking with
resultant decrease in capacity
Lubricating guide for Grinder/Sander (except turbine) and Drill
Brand
BP
Castrol
Esso
Q8
Mobil
Shell
Texaco
Molycote
Useful information
Log in to Atlas Copco www.atlascopco.com
You can find information concerning our products, accessories, spare parts and
published matters on our website.
Ergonomic guidelines
Consider your workstation as you read through this list of general ergonomic
guidelines and see if you can identify areas for improvement in posture, compo-
nent placement, or work environment.
• Take frequent breaks and change work positions frequently.
EN
General purpose
Bearings
Energrease LS-EP2
Spheerol EP L2
Beacon EP2
Rembrandt EP2
Mobilegrease XHP 222
Alvania EP2
Multifak EP2
BR2 Plus
© Atlas Copco Industrial Technique AB - 9836 973020 20
Safety and operating instructions
Air lubrication
Energol E46
Arox EP46
Chopin 46
Almo oil 525
Tonna R32
Aries 32
See "Lubrication" in
Operating instructions
7