Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION & OPERATION
A. INSTALLATION
1. Take out the beer cooler from its package. Place the beer cooler on a
steady and horizontal surface, and make sure the beer cooler is at least
5inches/10 cm away from other appliances or wall on each side so as to
allow correct ventilation on the appliances, get better performance.
2. Install the tap handle connect the tap, make sure both end fit together
perfectly. (Show as Figure 6)
3. Set the water drip tray into the notch provided. (Show as figure 7)
4. Plug the beer cooler.
Note: Do not connect or disconnect the electric plug when your hands are
wet. Before use it, make sure the voltage is conformity with plug mark,
and check whether the power cord is well connected or not; if not, please
don't use it, and call service center;
5. Put 800ml water into the cooling cavity or pour the water to the max
mark (Show as figure 8) (It can work without water, but it can't display
the best performance)
Note: Make sure the drain switch is at "Off" position, and no extra objects
Publicidad
