Maintenance And Cleaning - TECshow BEAMER 230 Manual De Usuario

13 13
14 14
15 15
16 16
17
18
19
20

9. MAINTENANCE AND CLEANING

The following points have to be considered during
the inspection:
1. All screws for installing the devices or parts of
the device have to be tightly connected and
must not be corroded.
2. There must not be any deformations on the
housing, color lenses, fixations and installation
spots (ceiling, suspension, trussing).
3. Mechanically moved parts must not show any
traces of wearing and must not rotate with
unbalances.
4. The electric power supply cables must not show
any damage, material fatigue or sediments.
Further instructions depending on the installation
spot and usage have to be adhered by a skilled
installer and any safety problems have to be
removed.
P. 12
Tecshow Beamer 230 |
English version
Tilt fine 0-255
Macro 0-255
0-25
26-76
Reset
77-127
128-255
0-25
Lamp
26-100
101-255
X/Y Time 0-255
Color Time 0-255
Speed 1 0-255
Speed 2 0-255
Fine control of Tilt movement
Macro
Motor reset
XY motor reset
All motor reset
Lamp off
Lamp on
Pan/Tilt speed from fast to slow
Color wheel speed from fast to slow
Prism/Frost/Strobe speed from slow to fast
Gobo speed from slow to fast
CAUTION!
Disconnect from mains before
starting maintenance operation.
In order to make the lights in good condition and
extend the life time, we suggest a regular cleaning
to the lights.
1. Clean the inside and outside lens each week
to avoid the weakneness of the lights due to
accumulation of dust.
2. Clean the fan each week.
3. A detailed electric check by approved electrical
engineer each three month, make sure that the
circuit contacts are in good condition, prevent
the poor contact of circuit from overheating.
Null
Null