Cleaning And Maintenance - TECshow DISCO SCAN Manual De Usuario

DMX-512 controller connection
3pins XLR signal output connector (female)
3pins XLR signal input connector (male)
1 earth 2 signal - 3 signal +
Light Outline and Dimension
DISCO SCAN
ENGLISH VERSION
DMX Address Setting
Set an address for each light, and accept the DMX signal from
DMX controller, as per the demand, user can set the same ad-
dress for all lights, or different address for different light.
If set several light with the same DMX starting address, all
lights will accept the same DMX signal from DMX controller
and work synchronously.
If set different address for each light, the light will accept sig-
nal from the DMX controller as per the DMX starting address,
if use this way, user must set the DMX starting address for the
light according to channel quantity of each light.
Rigging and installation:
1. The light can work properly when the ambient tempera-
ture is -25~40Cº, do not use the light when the ambient tem-
perature is over 40ºC or under -25ºC.
2. The installation has to be built and constructed in a proper
way that the rigging can hold 10 times of the light weight .
3. Don't stand under the light when installing, disassemble-
ing, repairing or maintaining the light.
4. Please use safety chain to ensure good installation.
5. Fix the M8 screw of the hook clamp in ₡12.5mm hole of the
light handle.

Cleaning and maintenance

Maintenance should be performed every 15-day period, by
using a sponge which is dipped with alcohol, rather than wet
cloth or other chemical liquid, to clean the mirror.
Always disconnect from the mains when the device is not in
use or before cleaning it.
CAUTION
Make sure power off before cleaning and maintenance!
WARNING!
Never look directly into the light source to avoid
hurt to eyes(especially meant for epileptics)!
WARNING!
Any power connection can be done only by tech-
nician !
p. 6