GreenWorks G24PS20 Manual Del Operario página 8

Make sure that it is turned over periodically to keep
symmetrical wear on the bar.
1. Lubricate the bearings on the nose sprocket (if present)
with the syringe (not included).
2. Clean the bar groove with the scraping hook (not
included).
3. Clean the lubrication holes.
4. Remove burr from the edges and level the cutters with a
flat file.
Replace the bar if:
• the groove is not fit with the height of the drive links
(which must never touch the bottom).
• the inside of the guide bar is worn and make the chain
lean to one side.
6 TRANSPORTATION AND
STORAGE
Before you move the machine, always
• Remove the battery pack from the machine.
• Keep hands clear of the lock-out button.
• Put the scabbard on the guide bar and the chain.
Before you put the machine into storage, always
• Remove all residual oil from the machine.
• Remove the battery pack from the machine.
• Clean all unwanted material from the machine.
• Make sure that the storage area is
• Not available to children.
• Away from agents which can cause corrosion, such as
garden chemicals and de-icing salts.
7 TROUBLESHOOTING
Problem Possible cause
The machine does The poles are not
not start. assembled cor-
rectly.
The lock-out but-
ton and trigger are
not depressed at
the same time.
NOTE
Solution
Assemble the
poles according to
the instructions.
1. Push and hold
the lock-out
button
2. While you
hold the lock-
out button,
pull the trig-
ger.
3. Release the
lock-out but-
ton to start the
machine.
English
Problem
The bar and chain
gets hot and
smokes.
The bar and chain
gets too hot and
can not cut.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3
seconds.
8 TECHNICAL DATA
Voltage
No load speed
Guide bar length
Chain stop
Chain oil capacity
Weight (without battery
pack)
Measured sound pressure
level
Guaranteed sound power
level
Vibration
Chain
7
Possible cause Solution
Oil tank is empty. Fill the oil tank.
1. Remove the
battery pack.
The discharge
2. Remove dirt
port is blocked.
from the dis-
charge port.
1. Clean the oil
tank.
Inlet opening of
inner oil tank is
2. Fill with clean
blocked.
bar and chain
lubricant.
The sprocket is 1. Clean the
stuck and clogged sprocket.
with debris.
2. Fill with clean
bar and chain
lubricant.
The chain tension Refer to Adjust
is too tight or too the Chain Tension
loose. in the manual.
Sharpen or re-
The chain is dull
place the chain.
Take out the chain
The chain is put
and turn it in the
on backwards.
right direction.
1. Release the
When you use the
trigger.
machine under
2. Start the ma-
load, it stops.
chine again.
Lubricate the
The chain is not
chain to decrease
lubricated.
the friction.
24V DC
6.7 m/s
200 mm
< 2 s
50 ml
3.2 kg
L = 88 dB(A), K
pA
dB(A)
L = 104 dB(A)
wA.d
2
< 2.5 m/s , K = 1.5 m/s
91PJ033X/CL15033X/
91YOS-33E
EN
= 3
pA
2