hillvert HT-GT-600HP Manual De Instrucciones página 25

The trimmer line must be 55 cm long and must always be installed in sets. There must be two cables
attached to both sides of the trimmer head.
3.3. Working with the HT-GT-600HP
3.3.1. STARTING THE ENGINE:
a) The device is supplied without oil. Oil should be filled before the first startup.
b) Check the oil level before each start-up. The oil level must always be between the min. and max.
on the dipstick. Always use SAE-30 oil.
c) Use only unleaded 95-octane gasoline. Never overfill the fuel tank
d) Set the throttle (C) on the handle to the max position.
e) Set the suction to the max position. Move the throttle lever fully to the left. Suction is not required
if the engine is hot.
f) Pull the starter cord to start the engine. Always insert the starter cord back into the engine by hand.
g) When the engine is started and warmed up, set the suction to the minimum (fully clockwise).
3.3.2. Work
Before using the machine, remove all foreign objects from the work area. Stones, glass, branches, and similar
objects can damage the machine. Also, check that all screws are tightened.
Never attempt to move the machine other than as intended for normal use when the engine is running.
KEEP A SAFE DISTANCE OF 15 METERS.
The machine has a low center of mass and large wheels. This makes it suitable for slopes of up to 15%.
Warning: Avoid driving on slopes steeper than 15%, as in this case, the engine will lack lubrication, which may
lead to damage.
The machine's workload should balance its performance.
This is ensured by always maintaining the same constant speed on the machine head. Avoid a drop in speed.
A drop in speed on the trimmer head can be a sign of overload.
When the machine is in operation and with the engine running, do not leave the work zone marked with
arrows in Figure A7. If it is necessary to leave the work zone, for example, to install accessories, stop the
engine first.
3.3.3. Cutting height adjustment
Follow the adjustment procedure as shown in Figure A8.
It is possible to adjust the cutting height on the trimmer head in several positions between 45-90 mm.
To adjust the cutting height, loosen the two 4mm screws shown in Figure A8. The trimmer head can then be
adjusted up and down. After selecting the desired cutting height, tighten both screws again.