hillvert HT-GT-600HP Manual De Instrucciones página 26

3.4. Description of the HT-GT-600SP
3.5. Installation of the HT-GT-600SP
Note: Product drawings can be found at the end of the manual in section 3.8. Drawings .
a) Install the lower steering wheel with 4 screws on the console. Then install the upper steering wheel.
The spacers must be on the inside. As shown in Figure B2 - A.
b) Attach the clutch handles to the steering wheel as shown in Figure B2-B. The cable coming out of
the right side of the chassis should be attached to the right side of the steering wheel. Similarly for
the left side.
c) Install the wheels with the screws shown in Figure B3 - A. The struts must be between the wheel
and the screw.
d) Install the protective cover on the machines as shown in Figure B4.
e) Install the trimmer cable. Follow the procedure step 1-2-3 as shown in Figure B5.
f) Install the gas lever on the handle, as shown in Figure B6.
Figure B1:
A. Starter cord
B. Mower starting handle
C. Drive handle
D. Engine
E. Wheel
F. Mower cord
G. Mower head
H. PVC cover
I. Gas lever
J. Protection shield