Publicidad
Step 6
Unfold the BACK (G) and lay it over the top of your unit.
å
Place the BACK (G) into the lower edges of the ENDS (A and B).
å
Fasten the BACK (G) to the BRACE (E). Use four CLIPS (67G) and four
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: The CLIPS should wrap around the edge of the BACK and the teeth
å
of the CLIP should bite into the BRACE and BACK as you tighten the screws.
NOTE: You should start each SCREW a few turns before completely
å
tightening any of them.
www.sauder.com/service
G
A
BLACK 9/16" LARGE HEAD SCREW
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1S
(4 used in this step)
427017
Caution
Lower edge
B
E
8
67G
Page 11
Publicidad
