Publicidad
Step 7
We have provided a Nail Holder tool to use in this step for proper positioning of the NAILS. Please refer to the parts of the
å
Nail Holder as the bead, off set edge, and nail slot as shown in Diagram 1.
Diagram 2. To fasten the top edge of the BACK (G), place the off set edge of the Nail Holder down against the TOP (H). Place a
å
NAIL (1N) into the nail slot of the Nail Holder. Tap the nail through the BACK and into the edge of the TOP (H). Remove the Nail
Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the BACK to the TOP with the hammer
and Nail Holder placing NAILS approximately 6 to 7-1/2" apart.
Diagram 3. To fasten the side edges, turn a
å
BACK (G) approximately 3" from the corner. Finish fastening the BACK to the RIGHT END using four additional
7/16" LARGE HEAD SCREWS (6S) spaced
Off set edge
Nail
Holder
Bead
3"
Insert the tip of
3.
each SCREW
between the
END and BACK.
Page 12
BROWN 7/16" LARGE HEAD SCREW (6S)
approximately 7" apart. Repeat this process for the LEFT END (B).
Nail slot
(4 used along the top edge)
1.
H
G
A
BROWN 7/16" LARGE HEAD SCREW
(10 used along the side edges)
between the RIGHT END (A) and
1N
Bead
NAIL
6S
427017
8
BROWN
1-1/2"
2.
Nail slot
B
www.sauder.com/service
Publicidad
