Revel RB-1032 Manual página 38

the blade's movement at the point of pinching.
Kickback is the result of power tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below:
• Maintain a firm grip on the power tool and position your body and arms to allow
you to resist kickback forces. Always use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during start-up. The operator can control
torque reactions or kickback forces, if proper precautions are taken.
• Never place your hand near the moving accessory. The accessory may kickback over
your hand.
• Do not position your body in the area where the power tool will move if kickback
occurs. Kickback will propel the power tool in the direction opposite to the blade's
movement at the point of snagging.
• Use special care when working corners, sharp edges, etc. Avoid bouncing and
snagging the accessory. Corners, sharp edges or bouncing have a tendency to snag
the rotating accessory and cause loss of control or kickback.
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the power tool's construction
and design:
• Damage to lungs if a dust mask is not worn.
• Damage to hearing if hearing protection is not worn.
• Health defects resulting from vibration emission if the power tool is being used over
longer period of time or not adequately managed and properly maintained.
• Injuries and damage to property to due to broken accessories that are suddenly dashed.
Warning!
This power tool produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk
of serious or fatal injury, we recommend persons with medical implants to consult their
physician and the medical implant manufacturer before operating this power tool.
INFORMATION ABOUT THE POWER TOOL
Intended use
This circular saw is intended for cutting wood.
Use the power tool for its intended purpose only. Any other use is deemed to be a case
of misuse. The user/owner of this power tool, not the producer, is responsible for any
damages or injuries caused by improper handling of this power tool.
EN 38